MODEL G5347
1
⁄
2" EXTREME DUTY
IMPACT WRENCH
INSTRUCTION SHEET
Air Valve
Knob
EYE/EAR INJURY HAzARD!
Wear safety glasses and
hearing protection when
using this tool!
INJURY HAzARD!
Always disconnect tool from
air to prevent unexpected
operation during service!
DO NOT EXCEED 120 PSI!
Exceeding this PSI may
result
damage.
in
injury/tool
Figure 1. Model G5347
SHATTERING HAzARD!
Use sockets rated for
impact wrench use only.
Air Supply
The impact wrench MuST be regularly lubricated.
Place 3-4 drops of air tool oil directly into the
air fitting before each use. For best results, we
recommend using an in-line filter, lubricator, and
regulator, as shown in Figure 2.
Specifications
Drive Size.........................................................1/2
"
Bolt Size Capacity ...........................................9/16"
No-Load Speed ................................... 7000 RPM
Maximum Torque .................................... 400 ft/lb
Air Inlet Size ............................................ 1/4" NPT
Air Consumption..................................... 4.5 CFM
Operating Pressure ................................... 90 PSI
Weight ..........................................................6 lbs.
Quick
Connector
Quick
Connector
Lubricator
Regulator
Your
Tool
Air
Compressor
Quick
Coupler
Quick
Coupler
Air Hose
Filter
Operation
1
Attach any ⁄2" drive socket onto your air impact
Figure 2. Installing your tool.
wrench. To change the rotational direction, push
the air valve knob. To adjust the torque setting,
turn the air valve knob from 0 to 5, 5 being the
highest setting (Figure 1). Connect the impact
wrench to an air line regulated at 90 PSI.
If you need help with your new pneumatic tool,
call our Tech Support at: (570) 546-9663.
COPyRIGhT © MAy, 2008 By GRIzzLy INDuSTRIAL, INC.
WARNING: NO PORTION OF THIS MANUAL MAY bE REPRODUCED IN ANY SHAPE
OR FORM WITHOUT THE WRITTEN APPROvAL OF GRIzzLY INDUSTRIAL, INC.
#JM10778 PRINTeD IN TAIWAN
|