TO REPLAcE BATTERiES
OVER 18 Months to 5
½
Years
Use a Phillips/cross head screwdriver
34849/34676
(not included) to loosen screw in battery
compartment door located on the bottom of
the SIT ‘N SPIN base (screw remains attached
to door). Remove door. Remove and discard
batteries. Insert 2 x 1.5V “AA” or R6 size
batteries. Alkaline batteries recommended.
Replace door and tighten screw.
CAUTION: TO AVOID BATTERY LEAKAGE
*
®
Sit ‘n Spin
1. Be sure to insert the batteries correctly and always follow the toy
and battery manufacturers’ instructions;
Includes: SIT ‘N SPIN base, center post (2 pieces), 3 screws and turn handle.
2. Do not mix old and new batteries or alkaline, standard (carbon-
zinc) or rechargeable (nickel-cadmium) batteries;
3. Always remove weak or dead batteries from the product.
Adult assembly required.
Phillips/cross head screwdriver (not included) needed for assembly.
IMPORTANT: BATTERY INFORMATION
Please retain this information for future reference. Batteries should be replaced by an adult.
CAUTION:
1. Always follow the instructions carefully. Use only batteries specified and be sure to insert item
correctly by matching the + and – polarity markings.
2. Do not mix old batteries and new batteries or standard (carbon-zinc) with alkaline batteries.
3. Remove exhausted or dead batteries from the product.
4. Remove batteries if product is not to be played with for a long time.
5. Do not short circuit the supply terminals.
6. Should this product cause, or be affected by, local electrical interference, move it away from other
electrical equipment. Reset (switching off and back on again or removing and re-inserting batteries) if
necessary.
7. RECHARGEABLE BATTERIES: Do not mix these with any other types of battery. Always remove from
the product before recharging. Recharge batteries under adult supervision. DO NOT RECHARGE
OTHER TYPES OF BATTERIES.
FCC STATEMENT
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15
of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a resi-
dential installation. This equipment generates, uses and can radiate radio frequency energy, and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio communications. However, there
is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna. • Increase the separation between the equipment and the receiver. •
Consult the dealer or an experienced radio/TV technician for help.
Thank you for purchasing
© 2006 Viacom International Inc. All Rights Reserved.
this PLAYSKOOL toy!
Nickelodeon, Nick Jr., Go, Diego, Go!. and all related titles, logos and
characters are trademarks of Viacom International Inc. “Go, Diego, Go! Theme”
* written by George Noriega and Joel Someillan. Published by Cutting Cane
Publishing (ASCAP), Tunes by Nickelodeon Inc. (administered by Famous Music
Corporation ASCAP), Late Man Music (BMI), and Music by Nickelodeon Inc.
This product contains small parts which
are necessary for the assembly. Prior to
1.5VAA or R6 size
x2
and during assembly of this product,
BATTERIES INCLUDED
keep small parts out of children’s reach.
Small parts pose a choking hazard to
children under 3 years.
7HRHS
Replace with 2 x 1.5V “AA” or R6 size batteries.
Alkaline batteries recommended. Phillips/cross head
screwdriver (not included) needed to replace batteries.
(administered by Ensign Music Corp. BMI). ®* and/or TM* & © 2006 Hasbro.
All Rights Reserved. TM & ® denote U.S. Trademarks
ꢀBNL
34849/34676
P/N 6631720000
|