HDA2020ZBB—Built-In Dishwasher
Wood Insert Cut-Out
Dimensions (in inches)
Dishwasher Dimensions (in inches)
Installation Information
(in inches)
24
25-1/8*
Countertop
90°
This wall area
must be free of
A
90°
pipes or wires
23-3/8*
Door insert
24"
Electrical
4
5
4
5
MIN.
wiring is
3" from
cabinet
4
Hot
water
line on
left
24-3/4
Electrical
wiring on
right
34-1/2±1/4"
Underside
of countertop
to floor
Access insert
6
6
C
34" MIN.
adj. to 35"
Plumbing and electrical
service must enter
inside shaded area
2
B
19" MIN. from wall
24" From wall
21-1/2*
*Add 1/4" for
*rear insulation
Panel
Thickness
1/4”
24" MIN.
3-1/4
Models/Kits
GPF325 Kit
A
B
C
4 (Adjustable)
18-7/8” 23-9/16” 3-11/16”
4-1/4” to
GPF375 Kit 18-15/16” 23-5/8”* 3-3/4”**
3/4”
*Bottom of panel must be notched 1-1/2"x1/2" to clear
across panel
Electrical Rating
Note: Dishwasher must not be installed more than 10' from sink
for proper drainage. All plumbing and electrical work must be in
accordance with local codes. Dishwasher includes drain hose
and leveling legs.
Voltage AC.......................................................120
Hertz ..................................................................60
Total connected load amperage.......................8.6
Calrod® heater watts.......................................500
For use on adequately wired 120-volt, 15-amp
circuit having 2-wire service with a separate
ground wire. This appliance must be grounded
for safe operation.
**Adjustment required to match adjcent cabinets fronts due to
leveling leg adjustment, 4" nominal.
Installation Information: Before installing, consult installation
instructions packed with product for current dimensional data.
®
For answers to your Monogram, GE Profile
™
™
Performance Series, GE Profile, GE,
Hotpoint and RCA appliance questions, call
GE Answer Center® service, 800.626.2000.
Listed by
Underwriters
Laboratories
R
Created 8/97
|